Sofa frames
Sides, arms and back rails dowelled and screwed, square enough for the upholstery line to work off.
Sofa frames · DT743, Bình Dương
Most jobs arrive as a photo of a finished piece. We read the frame off it, cut the parts on the router, drill and assemble them, then pack them the way a container loads: banded per unit, counted, labelled.
Plywood frames for anything that gets foam and fabric over it: sofas, armchairs, modular runs, sofa beds, headboards, benches. Cut and assembled in the same building.
Sides, arms and back rails dowelled and screwed, square enough for the upholstery line to work off.
Narrower frames with curved arms and a shaped back, cut from the same 18 mm board as the run.
Corner pieces and chaise ends cut to join the run, so the seams still line up once the covers go on.
Mechanism cut-outs and hinge points bored before assembly, so the metal drops straight in.
Panelled headboards and bed frames, drilled for legs or wall fixings.
Box frames decked flat for webbing or foam, square to the floor.
Cutting and assembly happen in the same building, so a part that comes off the bed wrong is caught before it reaches your line.


Plywood is the only material we run, so most of the work is in the cut and the joint. Five close-ups of what that looks like.





A photo of the finished piece, front and back if you have them. A sample, a shop drawing or a DXF all work too.
We pull out the parts, the joints and the hardware, and write down what we still need to know before cutting.
One frame or one set, sent for your approval before anything else is cut.
Cut and assembled in runs sized to a container, so smaller orders can share one load.
Dimensions, squareness, hole positions and face quality, then banded, counted and labelled per unit.
Packed to go straight into the container, or delivered to your factory in Bình Dương or Hồ Chí Minh City.
Plywood is the default. We cut MDF or HDF when a painted face is wanted and the part does not need to hold a screw.
| Board | Where it goes | What it does |
|---|---|---|
| Rubberwood | Sofa and chair frames | Holds screws and dowels well, machines clean. |
| Acacia or eucalyptus | Bed rails, structural frames | Denser and stiffer, better thread in thin sections. |
| Birch or poplar | Drawer boxes, visible parts | Cleaner face, lighter to handle. |
| MDF / HDF | Panels and backs | Smooth face for paint. Not for joints under load. |
Glue class E0 or E1 as specified. Standard thicknesses 5.5, 9, 12, 15 and 18 mm; other thicknesses on order.
A photo of a finished piece is enough to start. We read the frame from it, tell you what we still need to know, and quote by the container load.